Turn signal arm repair kit. You will need to remove the cover on your old arm exposing bare metal.Covers existing metal arm using JB weld, This was 3d printed by Anthony Vernon. Pictures below are for reference on how to attach these to your broken arm EPOXY not included.
Price: $20.00ea
OEM Mitsubishi Diamond Emblem, Adhesive type.
Turbo and non turbo.
Price: $29.99ea
OEM White plastic retaining clip for front grill and also the plastic cowling under wipers.
...--
Price: $3.49ea
OEM Alternator bracket. Used when no air conditioning bracket is used.
....
Price: $11.99ea
NOS Elgin industries new water pump- for 83-87 Listed for 1983 up to 12/86( no pipe for turbo coolant line that 88-89 use) Steel impeller, with all the engines and parts being swapped, best to just check to see if yours has the added pipe on the pump for turbo coolant or if it's on the tube that wraps around the passenger side and back of engine.
Price: $32.95ea
New water pump with Steel impeller for 88-89 Listed for 12/86 to 1989 ( has pipe for turbo coolant line. ) Steel impeller, with all the engines and parts being swapped, best to just check to see if yours has the added pipe on the pump for turbo coolant or if it's on the tube that wraps around the passenger side and back of engine.
Price: $41.85ea
Brand new Idler pulley for adjusting Air conditioning belt.
Price: $31.95ea
Air conditiong belt for cars 1983-1989
Price: $14.99ea
New power steering belt for 1983-1989 cars.
Price: $8.99ea
New belt for 1983-1987 Alternator and water pump ** 1988-1989 use a different width belt.
Price: $12.99ea
Brand new Belt for 1988-1989 cars- Alternator and water pump.
1988-1989 only unless you run an earlier pulley
Price: $12.50ea
Hood prop rod grommet. Used along with the hood prop rod clip below.
Price: $3.18ea
Hood prop rod retaining clip (Yes the one that's always broken!). Used along with the hood prop rod grommet listed above.
Price: $5.99ea
OEM windshield clip MB198536 to hold upper trim in place 6 required per car
Price: $5.25ea
OEM clip MB189627 to hold scuff plate in place- I think it takes 4 per side- this is the trim piece just by hatch and fuel door levers when you open the door
Price: $3.85ea
OEM clip MB083120 to hold front grill in place, this is used on each end of grill that the screw goes in to 2 required per car
Price: $3.85ea
OEM grommet MB088341 for starion/conquest fuel door and rear bumper support, also fits other mitsubishi vehicles and places, verify your part number
Price: $1.98ea
OEM grommet MS480009 for starion/conquest headlamp housing, also fits other mitsubishi vehicles and places, verify your part number
Price: $4.98ea
OEM clip that goes in fender for screw that holds front side marker lights on, I removed the little foam gasket before installing mine.
Price: $3.99ea
OEM hood release cable. For 87-88-89 model years. Brand new cable assembly.
Starion Conquest only.
..--
Price: $99.99
Brand new brake/clutch pedal pad. Replace that worn rubber pedal cover.
Starion Conquest only.
Price: $9.60ea
Brand new accelerator pedal pad. Replace that worn rubber pedal cover.
Starion Conquest only.
Price: $9.99ea
Brand new OEM center wheel cap for 7", 8", and 9" wheels.
OUT OF STOCK--- NO LONGER AVAILABLE
OUT OF STOCK--- NO LONGER AVAILABLE
Price: $00.00ea
OEM oil fill cap.
....
Turbo and non turbo.
Price: $27.98ea